User's Manual

Connecting the printer Setting up your printer
10
` Connecting the printer
Checking the
printer voltage
Make sure that the device has been set to the correct voltage (e.g. 230 V in
Europe, 120 V in the USA). To do this, check the type plate at the back of the
printer. Contact your dealer if the setting is incorrect.
Never switch on the printer if the voltage setting is incorrect, since this
may result in severe damage.
Connecting the
mains power
Connecting the
interface cable
The printer by default is provided with a parallel Centronics interface and an
USB interface.
For further information about the interfaces, refer to the User Guide on the Online
CD-ROM.
STOP
1. Make sure that the power switch of
the printer is in the Off position.
2. Connect the power cable to the power
inlet of the printer. Connect the power
cable plug to a mains socket.
1. Make sure that the printer and the
computer are switched off
2. Connect the data cable between the
printer and the computer, in this
example a 36-pin centronics parallel
cable.
QSG2440
_
en
_
396957
-.
book
Seite
10
Donnerstag
,
22
.
November
2007
11:31
11