Operation Manual
Table Of Contents
- CONTENTS
- NOTICE TO USERS
- TOSHIBA QUALITY IS SECOND TO NONE
- PREFACE
- FEATURES OF THE e-STUDIO520/600/720/850
- GENERAL PRECAUTIONS
- DISCLAIMER NOTICE
- 1. BEFORE USING EQUIPMENT
- 1. Description of Each Component
- 2. Turning Power On / Shutdown
- 3. Energy Saving Mode
- 4. Setting Copy Paper
- 2. HOW TO MAKE COPIES
- 3. SETTING OF BASIC COPY MODES
- 1. Paper Selection
- 2. Enlargement and Reduction Copying
- 3. Selecting Finishing Modes
- 4. Duplex Copying
- 5. Original Mode
- 6. Copy Density Adjustment
- 4. IMAGE ADJUSTMENT
- 5. USING THE EDITING FUNCTIONS
- 6. e-FILING
- 7. TEMPLATE
- 8. JOB STATUS
- 9. BLINKING GRAPHIC SYMBOLS
- 10. WHEN THIS MESSAGE APPEARS
- 1. “Toner low”
- 2. “Check staple cartridge”
- 3. “Check staple cartridge in the saddle stitch unit”
- 4. “Examine stapler”
- 5. “READY (CHECK STAPLER)”
- 6. “Examine stapler in the saddle stitch unit”
- 7. “READY (CHECK SADDLE STITCH STAPLER)”
- 8. “READY (HOLE PUNCH DUST BIN IS FULL)”
- 9. “POWER FAILURE”
- 10. “Time for periodic maintenance”
- 11. “Check paper size setting on control panel for drawer N”
- 12. “Reboot the machine”
- 11. MAINTENANCE
- 12. SPECIFICATIONS & OPTIONS
- INDEX
163
5
17. TAB PAPER
Tab paper copying and insertion are available. There are the following 3 modes.
1. Copying on the tab of tab paper ([COPY ON TAB])
2. Inserting blank tab paper prior to a selected page ([BLANK TAB INSERT])
3. Combination of copying on tab paper and inserting tab paper ([COPIED TAB INSERT])
• Before copying on tab paper, adjust the tab width. ( P.166)
• The tab paper can be set in any one drawer and the bypass tray except Large Capacity Feeder. (The
recommendation is to set in the 2nd drawer.)
• Be sure to set “TAB PAPER” for the drawer for special uses. ( P.46 “Drawer for special uses”)
• Only A4/LT can be used in this mode.
Preparing an original to copy on the tab of the tab paper
A4/LT originals are used. In copying on tab or copied tab insert, the image is shifted to copy the index of
the original on the tab position.
1 2 3
Original
* The shift width means the distance that
image should be shifted when copied
on the tab paper.
Shift width*Tab width
Tab paper
By setting the tab width and shift width, the image is shifted to copy the index of the original on the tab position.