Operation Manual
Table Of Contents
- CONTENTS
- NOTICE TO USERS
- TOSHIBA QUALITY IS SECOND TO NONE
- PREFACE
- FEATURES OF THE e-STUDIO520/600/720/850
- GENERAL PRECAUTIONS
- DISCLAIMER NOTICE
- 1. BEFORE USING EQUIPMENT
- 1. Description of Each Component
- 2. Turning Power On / Shutdown
- 3. Energy Saving Mode
- 4. Setting Copy Paper
- 2. HOW TO MAKE COPIES
- 3. SETTING OF BASIC COPY MODES
- 1. Paper Selection
- 2. Enlargement and Reduction Copying
- 3. Selecting Finishing Modes
- 4. Duplex Copying
- 5. Original Mode
- 6. Copy Density Adjustment
- 4. IMAGE ADJUSTMENT
- 5. USING THE EDITING FUNCTIONS
- 6. e-FILING
- 7. TEMPLATE
- 8. JOB STATUS
- 9. BLINKING GRAPHIC SYMBOLS
- 10. WHEN THIS MESSAGE APPEARS
- 1. “Toner low”
- 2. “Check staple cartridge”
- 3. “Check staple cartridge in the saddle stitch unit”
- 4. “Examine stapler”
- 5. “READY (CHECK STAPLER)”
- 6. “Examine stapler in the saddle stitch unit”
- 7. “READY (CHECK SADDLE STITCH STAPLER)”
- 8. “READY (HOLE PUNCH DUST BIN IS FULL)”
- 9. “POWER FAILURE”
- 10. “Time for periodic maintenance”
- 11. “Check paper size setting on control panel for drawer N”
- 12. “Reboot the machine”
- 11. MAINTENANCE
- 12. SPECIFICATIONS & OPTIONS
- INDEX
50
1.BEFORE USING EQUIPMENT
4.Setting Copy Paper (Cont.)
1
3
Push the drawer of the Tandem Large Capacity Feeder straight into
the equipment until it comes to a stop.
• Close the drawer completely. The elevator tray automatically moves up to the paper feeding position.
Be careful not to let your fingers be caught when closing the drawer. This could injure you.
Setting paper in the External Large Capacity Feeder (optional)
2
Open some packages of paper, take out
entire reams of paper and set them
aligned in tray A and tray B with their
copy side down.
• For the maximum number of sheets that can be set, see P.37
“Copy paper types and sizes”.
• Be sure that the paper height does not exceed the line indicated
on the side guide.
• Fan and jog the paper well before placing them on the trays. Set
the paper for A to the right side, and set it for B to the left side.
(The paper can be set neatly if you pile it up gradually and alter-
nately in trays A and B.) Be sure that the centre lever is not open
(see the labels attached in the Tandem Large Capacity Feeder).
• Paper starts being fed out of the elevator tray A at first. When
the paper on the tray A has run out, the paper on the tray B
moves to the position of A and starts being fed.
• Do not use creased, folded, wrinkled or damp sheets of paper.
1
Pull out the External Large Capacity
Feeder carefully until it comes to a stop.
A: Slide rail
B: Elevator tray
• Be careful not to touch the slide rail.
B
A
A
A
B