Operation Manual

2. MAIN UNIT REPLACEMENT
EO18-11004A
2.6 Replacing the Control Lock Ass’y
2- 6
2.6 Replacing the Control Lock Ass’y
1) Remove the Top Cover Ass’y. (Refer to Section 2.1 Removing the Top Cover Ass’y.)
2) Peel off the Key Switch Panel from the Top Cover. And then remove the two P-3x8 screws to
remove the Control Lock Ass’y from the Top Cover.
3) Replace the Control Lock Ass’y with the new one, and then reassemble in the reverse order of
removal.
NOTE: Please use a new Key Switch Panel when reassembling.
2.7 Replacing the Binary Cylinder Lock Ass’y
(only for FS-1535 provided with the Binary Lock)
1) Remove the Top Cover Ass’y. (Refer to Section 2.1 Removing the Top Cover Ass’y.)
2) Peel off the Binary Lock Panel from the Bottom Cover.
3) Remove the Binary Cylinder Lock Ass’y Cable from CN9 on the MAIN PC Board, the two screws
securing the Binary Cylinder Lock Ass’y, then Binary Cylinder Lock Ass’y from the Bottom Cover.
4) Replace the Binary Cylinder Lock Ass’y with the new one, and then reassemble in the reverse
order of removal.
P-3x8
Control Lock Ass’y
Top Cover
Key Switch Panel
Binary Cylinder Lock Ass’y
MAIN PC Board
Bottom Cover
Screw
Binary Lock Panel
CN9