Operation Manual

3. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
EO18-11004A
3.1 RS-232C Connectors #1 to #3
3- 1
3. INSTALLATION PROCEDURE FOR OPTIONAL
EQUIPMENT
WARNING!
Be sure to unplug the power cord before installing any optional equipment.
3.1 RS-232C Connectors #1 to #3
The three COM Ports for Serial Interface (RS-232C) are provided with this ECR. Peripheral devices
corresponding with RS-232C are connectable to the above connectors, however, when connecting the
Scanner, it should be connected to RS-232C #1 (COM Port 1).
For each COM Port, Control Code (DTR/DSR or XON/XOFF), Baud Rate (4,800 to 19,200), Data
Length (7 bits or 8 bits), Parity Bit (None, Odd, or Even), Stop Bit (1 stop or 2 stops), etc. are
programmable. (For details, refer to the MA-1535 Series Programming Manual (Doc. No.: EO3-11101)
or the FS-1535 Series Programming Manual (Doc. No.: EO3-11104).)
3.2 Expansion Memory Board (KRAM-4/12-1530)
This option kit is an Expansion Memory Board to be connected to the MAIN PC Board. Two types of
the memory boards are provided according to the RAM capacity installed; 4MB or 12MB.
Installing Procedure
1) Remove the Top Cover Ass’y. (Refer to Section 2.1 Removing the Top Cover Ass’y.)
2) Connect the Expansion Memory Board to the CN13 on the MAIN PC Board.
3) Install the Expansion Memory Board, and then reassemble in the reverse order of removal.
COM2
COM3
COM1
MAIN PC Board
Expansion Memory Board
CN13