User's Manual
Table Of Contents
- PRECAUTIONS
- Precautions for Use
- About TOSHIBA Wireless Solution
- Wireless Interoperability
- Wireless LAN and your Health
- Safety Instruction for Wireless Products
- Regulatory Information
- Canada - Industry Canada (IC)
- Europe - EU Declaration of Conformity
- USA-Federal Communications Commission (FCC)
- Regulatory Notice for Channel Use in France
- Approved Countries/Regions for use for the Toshiba Wireless LAN
- NOTES!
- Table of Contents
- Setting Up Wireless Network
- Appendix
- INDEX
1. Setting Up Wireless Network
32 GN-1050 Operator’s Manual — Setting Up the Infrastructure Mode
3. Specify the following items and press the [NEXT] button.
z TRANSMIT POWER
Select the low transmit power if you want to limit the area that the wireless
communication is enabled. If you do not have to limit the area, select [100%].
z TRANSMIT RATE
Select the transmit data capacity for wireless communication. If you do not have
to specify the fixed rate, select [AUTO]. When [AUTO] is selected, this
equipment will use appropriate rate depending on the condition.
Generally select [AUTO]. The communication may fail unexpectedly if you
select a static transmit rate.
4. Confirm the settings and press the [FINISH] button.
• The shut down screen is displayed.
SUPPLEMENT: If you want to change the settings, press the [PREV] button to move back to the screen
that you want to change and then repeat the operation.
5. Press the [YES] button to shut down the equipment.
• The wireless settings apply after restarting the equipment.