User's Manual

User manual HANDY TERMINAL
31
☞
☞☞
☞ NOTE: You should always put the terminal in Suspend Mode when you change the battery pack; see Changing the
Main Battery Pack
on paragraph 4.18. When you replace the battery door, press the Power button to wake the
device. Pressing the front Scan key will not wake up the device when the battery door is
replaced.
Troubleshooting Suspend/Resume
If the terminal does not wake when you press the Power button, the main battery might be too low
to resume operation. To check, remove the battery and install a fully charged battery or connect the
terminal to a Handy Terminal charging peripheral.
4.24. Memory Allocation
You can verify file storage and program memory in System Properties.
1. Tap Start -> Settings -> Control Panel -> System -> Memory tab.
4.25. Care and Cleaning of the Products
When needed, clean the image engine window and the LCD display with a clean, non-abrasive, lint-
free cloth. The terminal can be cleaned with a damp cloth.
4.26. HT-K10 Technical Specifications
Model HT-K10
Operating System Microsoft Windows Embedded CE 6.0 Pro
Development
Environment
HT_SDK_Vxxx.msi
Application Software Tools and Demos
Processor Marvell® PXA 300 624MHz
Memory 128MB RAM X 128MB Flash
Storage Expansion
User accessible Micro SD memory card slot. Please contact your Toshiba sales
representative for available qualified card options.
Display 2.8 in. transmissive active matrix 65K color LCD with backlight, QVGA (240 x 320)