User's Manual

User manual HANDY TERMINAL

7.6. Using Demos

Handy Terminal Demos are software utilities loaded on Handy Terminals that demonstrate the

advanced features of the terminal.

To access these demos, tap Start > Programs > Demos.

• Select Scan Demo to verify decoding

7.7. Decoding a Bar Code

1. Tap Start > Demos > Scan Demo.

2. Position the Handy Terminal over one of the Sample Bar Codes on paragraph 7.8.

A range of 4-10 inches (10-25 cm) from the bar code is recommended.

3. Project the aiming beam by pressing and holding the Scan key. The Scan LED lights red

4. Center the aimer beam horizontally over the bar code and highlight all of the vertical bars of the

bar code. The aiming pattern is smaller when the terminal is held closer to the code and larger

when the terminal is held farther from the code. Symbologies with smaller bars or elements (mil

size) should be read closer to the unit whereas larger bars or elements (mil size) should be read

farther from the unit.

5. When the bar code is successfully decoded, the decode LED lights green and the terminal beeps.

7.8. Sample Bar Code

You can use the following bar code to verify decoding:

7.9. Scanning Positions

The aiming beam must be aimed across the entire bar code to provide you with the best scanning

performance. The aiming pattern is smaller when the terminal is held closer to the code and larger

when the terminal is held farther from the code. Symbologies with smaller bars or elements (mil

size) should be read closer to the unit whereas larger bars or elements (mil size) should be read

farther from the unit.

8. Using ScanWedge

8.1. Overview

ScanWedge sends data from the installed scan engine(N4313 or IT5300SR) to the foreground