Manual

MPEG2 sound

You can enjoy motion picture and live concert DVD video discs encoded via the MPEG2 recording system with dynamic

realistic sound by connecting an amplifier equipped with an MPEG2 audio decoder or MPEG2 audio processor.

_Amplifier equipped with an_

PEG2audiodecodeLJ

To COAXIAL L

type digital

audio input

Rear lower left of the TV

To COAXIAL DIGITAL

AUDIO OUT l

75 £2coaxial cable (not supplied)

2 channel digital stereo

You can enjoy the dynamic sound of 2 channel digital stereo by connecting an amplifier equipped with a digital audio input

and speaker system (right and left front speakers).

Note: PCM audio is limited to DVD or CD playback.

_" Rear lower left of the

Amplifier equipped with aq m_MMiiimmmmmi Tv

_ I I Digital audio input / .......

v I C==: ._-J /

IToCOAXlAL TeCOAXlALDIGITAL

I type digital _ AUDIO OUT

A I audi° input /

75 £2coaxial cable (not supplied)

Notes:

• DO NOT connect the COAXIAL DIGITAL AUDIO OUT jack of the TV/DVD to the AC-3 RF input of a Dolby Digital Receiver.

This input on your A/V Receiver is reserved for Laserdisc use only and is incompatible with the COAXIAL DIGITAL AUDIO

OUT jack of the TV/DVD.

• Connect the COAXIAL DIGITAL AUDIO OUT jack of the TV/DVD to the "COAXIAL" input of a Receiver or Processor.

• Refer to the owner's manual of the connected equipment as well.

• When you connect the TV/DVD to other equipment, be sure to turn off the power and unplug all of the equipment from the

wall outlet before making any connections.

• The output sound of the TV/DVD has a wide dynamic range. Be sure to adjust the receiver's volume to a moderate

listening level. Otherwise, the speakers and your hearing may be damaged by a sudden high volume sound.

• Turn off the amplifier before you connect or disconnect the TV/DVD's power cord. If you leave the amplifier's power on,

the speakers may be damaged.

J5X00221A [E] (P14-25) 19 _ 21/02/2006, 8:39 PM