Power Supply User Manual

B-16
1600XP Series Installation and Operation Manual
1600XP Command Parameters Table
Cmd
ID
Description
on LCD
Brief Description Location Map Example
Rqd Security
Level to change
By
Tab Block
810 Cali Disp Enable Calibration of Touch Panel Display
- If this is enabled, touch panel calibration will begin and end the user will be required to touch the target as accurately as possible
Settings D&R Disable Changeable
Changeable Changeable
User Administrator Service
811 P1X Cali Point#1 X Calibration Settings D&R 29372 Changeable
Changeable Changeable
User Administrator Service
812 P1Y Cali Point#1 Y Calibration Settings D&R 29598 Changeable
Changeable Changeable
User Administrator Service
813 P2X Cali Point#2 X Calibration Settings D&R 3906 Changeable
Changeable Changeable
User Administrator Service
814 P2Y Cali Point#2 Y Calibration Settings D&R 29798 Changeable
Changeable Changeable
User Administrator Service
815 P3X Cali Point#3 X Calibration Settings D&R 3922 Changeable
Changeable Changeable
User Administrator Service
816 P3Y Cali Point#3 Y Calibration Settings D&R 3038 Changeable
Changeable Changeable
User Administrator Service
817 P4X Cali Point#4 X Calibration Settings D&R 29286 Changeable
Changeable Changeable
User Administrator Service
818 P4Y Cali Point#4 Y Calibration Settings D&R 3028 Changeable
Changeable Changeable
User Administrator Service
821 1st Startup* First time startup
- If UPS is rst time startup, Display will guide the user through those commands necessary to setup the UPS properly.
Settings D&R Disable Changeable
Changeable
Administrator Service
822 Buzzer Silent Buzzer Silent Settings D&R 0 Changeable Service