Operation Manual

English
SETTING UP
16
Switching on
If the RED LED is unlit check that the mains plug is connected to the power supply. If the picture does
not appear press
on the remote control, it may take a few moments.
To put the television into Standby press
on the remote control. To view the television press again.
The picture may take a few seconds to appear.
Using the remote control
To set up the television you will now need to use the on screen menus. Press on the remote control
to see the menus.
The on-screen menu appears as a list of five topics. As each symbol is selected by pressing ◄ or ►on
the navigation ring on the remote control, its respective options will appear below.
To use the options, press

or

on the navigation ring to move up and down through them and use
, ◄ or ► to select the required choice. Follow the on-screen instructions. The functions of each menu
are described in detail throughout the manual.
Using the controls
To alter the volume press – +.
To alter the programme position press
P .
Press
and

,

, ◄ or ► to control the sound and picture options.
Press
to finish.
To select the external input, press
and then use

or

to move through the list until the
appropriate input source is selected as described on page 30.
Please always refer to the owner’s manual of the equipment to be connected for full details.
Please note: Inserting the headphone plug will mute the sound from all speakers.