Manual

Settingthe HDM]®audio mode
To set the HDMI audio mode:
MENU
Press O and open the Sound menu.
2 Highlight Audio Setup and press @.
3 Press A or V to select HDNI 1 Anfli0 and
then press 4 or _ to select the HDM[ 1 audio
mode (Ant0, Digital or AnaJ0g). (ARlo is the
recommended mode.) See "Connecting an HDM[
or DV[ device to the HDM[ input" (=:_>page 16).
Auto
Digital
Analog
When viewing the HDM[ l input, if
digital audio from the HDM[ input is
available, it will be output. [f not, the
TV will automatically detect and output
analog audio from the PC Audio input.
When viewing the HDM[ 1 input,
digital audio from the HDM[ input will
be output.
When viewing the HDM[ 1 input,
analog audio from the PC Audio input
will be output.
4 To save your settings, highlight Done and press
O
Note: Because the PC and HDMI-1 inputs
share the same set of analog audio inputs, the
PC Audio menu setting influences the NDM! 1
Audio menu setting. If PC Audio is set to "No,"
the NDM! 1 Audio setting changes to "Auto."
If PC Audio is set to "Yes," the HDMI 1Audio
setting is set to "Digital" and is grayed out in
the menu. (Also see item 3 on page 12 and
"Setting the PC Audio" on page 44.)
Viewing the digital signal meter
You can view the digital signal meter in the ANT/
CABLE digital TV input source only.
To view the digital signal meter:
MENU
1 Press O and open the Setup menu.
Highlight installationand press @E_.
A new set of installation menu icons will appear.
Open the Terrestrialmenu, highlight Signal
Meter, and press @.
4 Press AV4_ to select the antenna input and
digital channel whose signal you want to check.
Note:
• The physical digital channel number listed in
the Signal Meter screen may not correspond
to a virtual TVchannel number. Contact your
local broadcasters to obtain the RF channel
numbers for your local digital stations.
The signal strength does not change between
virtual channels on the same physical
channel.
To close the screen and return to the
Terrestrial menu:
Highlight Done and press @.
To return to normal viewing:
EXIT
Press O.
Setting the time zone
The Time Zone setup will allow you to specify the
correct time zone for your region. This feature will
allow the TV status information to show the correct
time zone information (_ page 50).
To set the time zone:
1 From the Setup menu, highlight Installation and
press @. A new set of Installation menu icons
will appear.
Highlight TimeZone, and press @.
Press 4 or _ to select the region, highlight Done,
and then press @.
After the time zone has been set, you will be asked to
set the current Daylight Saving Time status.
To set the Daylight Saving Time status:
1 Press 4 or _ to select Yesor No, highlight Done,
and then press @.
27