Operation Manual

14
Basic Operation
Note:
If the built-in tuner does not receive
anything (e.g. if no antenna is
connected) during TV-operation, then
the TV-unit will change to standby
after approx. 15 minutes.
•
Channel selection
With the numbered buttons.
Example:
No. 2: Press 0 and within 2 seconds, press 2.
No. 29: Press 2 and within 2 seconds, press 9.
Press CH
or to change up or down a channel. This takes
approx. 2 seconds. If the auto search only stored 5 stations,
only these 5 will appear. Skipped channels will not appear (see
page12).
The CH LIST shows a list of all receivable programmes.
They are located in channels 1 to 99.
Press CH LIST to display the CH LIST.
Press ▲ or ▼ to select the desired channel.
Press CH LIST to display the selected channel. Press EXIT to
exit.
•
•
QuickView
CH RTN
button allows you to go back to the last selected
channel.
Volume adjusting
Press VOL + or – to adjust the volume. The volume level
indicator disappears after 4 seconds.
MUTE
Press MUTE. The sound will be cut off. MUTE will appear for
approx. 4 seconds.
The muting can be released by pressing MUTE again or VOL +
or –.
Information display
In the analogue TV mode:
Press
. Channel number
and picture size setting
will appear for approx. 4
seconds.
In the digital TV mode:
Press
. The program
information will appear (see
‘Channel banner’ on page 27).
SLEEP TIMER
To set the sleep timer press SLEEP. SLEEP and the minutes will
appear. Each time you press SLEEP, the SLEEP time shown
will change in the order of 120, 110, 100, 90, 80, 70, 60, 50,
40, 30, 20, 10, 0. When the displayed time runs out, the unit
will switch to standby. The display will disappear after approx. 4
seconds.
To cancel the sleep timer:
Press SLEEP repeatedly until ‘0’ appears.
STEREO 1
ARD
AUTO
51Z0231A_ENG.indd 1451Z0231A_ENG.indd 14 9/16/08 3:28:45 PM9/16/08 3:28:45 PM