Owner`s manual

- 13 -
Controlling the TV
A wide variety of external equipment can be connected via the sockets located on the side and back of the
television. Whilst all the necessary adjustments and controls for the television are made using the remote
control, the buttons on the left side of the television may be used for some functions.
Switching on
If the standby LED is unlit, check that the mains plug is con-
nected to the power and press
the button on the left side of
the television to switch the television on. Then the LED lights
up in green. If the picture does not appear, press
on the
remote control; it may take a few moments.
To put the television into Standby, press
on the remote
control. To view the television, press
again. The picture
may take a few seconds to appear.
Note: The active Standby LED may appear for a few moments
when the TV is switched off.
For energy saving:
Turning the television off at its mains supply, or un-plugging
it, will cut energy use to nearly zero for all televisions. This
is recommended when the television is not being used for a
long time, e.g. when on holiday.
Reducing the brightness of the screen will reduce energy use.
Energy effi ciency cuts energy consumption and thus saves
money by reducing electricity bills.
NOTE: Putting the television into standby mode, will reduce
energy consumption, but will still draw some power.
Using the Remote Control
Press the MENU button on the remote control to see the
menus.
The main menu appears as a group of icons each for a menu
option. Press the
or button to select a topic, and press
OK button.
In sub menu screen mode the menu appears as a list. Press
the
or button to select a topic, and press OK button.
To use the options press the
and buttons on the remote
control to move up and down through them and OK,
or
buttons to select the required choice. Follow the on screen
instructions. The functions of each menu are described in
detail throughout the manual.
Using the Controls and Connections on the TV
Using the control buttons on the side of the TV:
•
To alter the volume press + or -. If the volume does not
change, press P/V-AV button twice and press + or -
again.
• To alter the programme position press P/V-AV button once
and then press + or - button.
• To select an external input, press and hold
P/V-AV button
until “Sources list” is displayed. To select an external input,
press P/V-AV repeatedly until the appropriate input source
is selected.
NOTE: The USB socket has limited functionality, and Toshiba
can take no responsibility for damage to other connected
equipment.
Please always refer to the owner’s manual of the equipment
to be connected for full details.
USB
5Vdc
Max:500mA
SIDE AV
Standby LED
Remote Control Sensor
+/- control/volume buttons
Programme / / AV FunctionVolume
Standby / On button
A01_MB60_[GB]_(IB_INTERNET)_DVB-TC_(CT90326)_10071224_10071226.indd 13A01_MB60_[GB]_(IB_INTERNET)_DVB-TC_(CT90326)_10071224_10071226.indd 13 02.06.2011 20:56:0402.06.2011 20:56:04