Operation Manual

English
41
CONTROLS AND FEATURES
Pass-Through Control
The Pass-Through feature allows you to control
the connected REGZA-LINK device by the
television’s remote control.
Press ▲ or ▼ to select REGZA-LINK in
the Quick Access Menu, and then press
OK. The control panel will appear.
When there are two or more REGZA-LINK
devices connected to the television, a
device selection menu will appear. Highlight
the device you want to control, and then
press to select.
GUIDE EXIT
MENU
MENU
CONTENTSROOT TOP DVD
RETURN
Press the key on the television’s remote
control as guided by the control panel
shown.
NOTE: The available functions are dependent
on the connected equipment, not all the remote
functions may be available. Please refer to the
operation manual of the connected equipment.
REGZA-LINK Menus
By activating the   feature
in the  setup menu, individual
REGZA-LINK features can then be activated.
One Touch Play
The function of  will automatically
power on the television that was in standby mode
and switch the television’s input source to the
port connected with the audio/video equipment
by powering-on or playing from the audio/video
equipment.
NOTE: This feature is dependent on the
connected equipment and television setting.
System Standby
This feature automatically switches the connected
equipment into standby when the television goes
into standby and conversely for the television to
switch into standby when connected equipment
goes into standby. It is selected in the 
 setup menu.
NOTE: This feature is dependent on the
connected equipment and television setting.
System Audio Control
Using the feature allows the
televisions remote control to adjust the volume or
mute the sound of the speakers connected to the
television via an AV amplier.
Ensure that the connected AV amplier and
 equipment are selected in the
input source selection and that the 
is set to  in the 
 setup menu.
NOTE: When the AV Amplier is switched on, its
input source changed or the volume adjusted,
the sound will be output from the AV Amplier’s
speakers even if TV Speakers has been selected.
Turn the television off then on again to output the
sound from the TV’s speakers.
The full function may not work and is dependent
on the Amplier being used.
Downloaded from www.Manualslib.com manuals search engine