Operation Manual

English
40
CONTROLS AND FEATURES
REGZA-LINK Controls
This feature uses  (Consumer Electronics
Control) technology, and allows the control of
Toshiba compatible equipment
from the television’s remote control.
NOTE: Not all Toshiba products currently support
REGZA-LINK.
Equipment Control
The  mode on the television’s
remote control allows the control of connected
 equipment being watched.
To control the  input source, rst
select the equipment with  input
source selection, then switch the mode on the
remote control to  and press any
buttons.
The available functions are dependent on the
equipment connected. Not all the remote control
keys may be available. Please refer to the
operation manual for each piece of equipment
connected.
NOTE: The television features that can be
controlled by the connected equipment are:
Standby, Volume, Channel, Sound Mute, Display
Information, Number Buttons and Previous
Programme.
Input Source Selection
When any equipment using technology is
connected, the  icon will appear
in the input source list allowing selection of
individual devices.
Press . A list will appear on screen
showing modes and all stored external
equipment.
Main
TV
1
2
3
HDMI 1
HDMI 2
HDMI 3
PC
4C
The  icon appears
automatically after detected with REGZA-
LINK compatible equipment. Press ▼ to
highlight the input source shown with the
 icon.
TV
1
2
3
HDMI 1
HDMI 2
REGZA-LINK
HDMI 3
PC
4C
Main
Press ►. A second selection screen will
appear showing all connected 
 equipment.
4
Press ▲ or ▼ to highlight an input source,
and then press to select.
NOTE 1: When the television is switched on,
it will take a few minutes for the REGZA-LINK
icon to appear in the list, when an HDMI cable is
removed, it will take a few minutes for the logo to
disappear.
NOTE 2: If the HDMI cable from the connected
equipment is changed, or HDMI equipment
settings are changed, the Enable REGZA-LINK
in the REGZA-LINK setup menu may need to be
reset to On.
NOTE 3: When the REGZA-LINK input source
is selected, some REGZA-LINK equipment may
automatically switch on.
The following features are dependent on the
connected equipment. For operating information,
refer to the operation manual for all connected
equipment.