Owner`s manual

- 14 -
Initial Installation
Before switching on the television put your decoder and media recorder to Standby if they are connected
and ensure the aerial is connected to your television. To set up the television use the buttons on the remote
control as detailed on page 8.
IMPORTANT: Ensure that the aerial or cable is
connected and a Common Interface module is not
inserted before switching on the TV for the fi rst time
installation.
Connect the mains plug and switch the TV into 1.
on using the side standby switch. If the TV does
not switch on, press any numbered or standby
button on the remote control, then the language
selection menu will be displayed. This screen will
appear the fi rst time that the television is switched
on and each time the television is reset.
By pressing the 2. Up or Down buttons highlight the
language you want to set and press OK button.
The following message will be displayed next:
By pressing 3. Left or Right button, select the
country you want to set and press Down button
to highlight Teletext Language option. Use
Left or Right button to select desired Teletext
Language.
Press 4. Down button after setting Teletext Language
option. Scan Encrypted will be then highlighted.
You can set Scan Encrypted as Yes if you want
to scan coded stations.
Press 5. OK button on the remote control to continue
and the following message will be displayed on
the screen:
Select 6. Yes by using Left or Right buttons and
press OK to continue. Afterwards, the following
OSD will be displayed on the screen (*):
If you select 7. Cable option, the following screen
will be displayed (*) :
You can select frequency ranges from this 8.
screen. For highlighting lines you see, use Up or
Down button. You can enter the frequency range
manually by using the numeric buttons on the
remote control. Set Start and Stop Frequency as
desired by using numeric buttons on the remote
control. After this operation, you can set Search
Step as 8000 kHz or 1000 kHz. If you select 1000
kHz, the TV will perform search process in a
detailed way. Searching duration will thus increase
accordingly. (*) When fi nished, press OK button
to start automatic search.
If you select 9. Aerial option from the Search Type
screen, the television will search for broadcasts.
A01_MB60_[GB]_(IB_INTERNET)_DVB-TC_(CT90326)_10071224_10071226.indd 14A01_MB60_[GB]_(IB_INTERNET)_DVB-TC_(CT90326)_10071224_10071226.indd 14 02.06.2011 20:56:0502.06.2011 20:56:05