Operation Manual

English
SETTING UP
19

AUDIO
DVB
COMMON
INTERFACE
HDMI 3
R
L
(3)
USB
VIDEO
GREEN LED -
On Timer/EPG Timer On
IR SENSOR
TOUCH SENSOR
CI Card
R
L
Video
USB
VIDEO INPUT
Headphone
RED LED - Standby
BLUE LED - Power on
HDMI 3
Switching on
Before switching on the television, make sure to
connect the aerial cable, and select TV as the
input source.
If the RED LED is off, check that the mains plug
is connected to the power supply. If the picture
does not appear, press on the remote control, it
may take a few seconds to appear.
To put the television into Standby mode, press
on the remote control. To view the picture, press
again. The picture may take a few seconds to
appear.
Using the remote control
To set up the television, you need to use the on-
screen menus. Press on the remote control to
see the menus.
The on-screen menu appears as a list of ve
topics. As each symbol is selected by pressing ◄
or ►on the navigation ring on the remote control,
its respective options will appear below.
To use the options, press

or

on the
navigation ring to move up or down through them
and use , ◄ or ► to select the required choice.
Follow the on-screen instructions. The functions
of each menu are described in detail throughout
the manual.
Using the side-panel controls
To alter the volume, press – +.
To alter the programme position, press
 
.
Press  and , , , or to control the
sound and picture options. Press  to nish.
To select the external input, press to move
through the list until the appropriate input source
is selected as described on page 38.
Please always refer to the owner’s manual of the
equipment to be connected for full details.
Using the touch sensor
To use Touch Sensor on the television, use your
finger to touch the indication on Touch Sensor.
To alter the volume, touch on – +.
To alter the programme position, touch on


.
Touch MENU and – + or
 
to control
the sound and picture options. Touch MENU to
finish.
To select the external input, touch to
move through the list until the appropriate input
source is selected as described on page 38.
Downloaded from www.Manualslib.com manuals search engine