Manual

Programmingchannelsintothe
TV'schannelmemory
When you press _ or _.J on the remote control or TV
control panel, your TV will stop only on the channels you
programmed into the TV's channel memory.
Follow the steps below- to program channels into the TV's
channel memory.
Programmin9channeJsautomatically
Your TV can automatically detect all active channels in your
area and store them in its memory. After the channels am
programmed automatically, you can manually add or erase
individual channels in the channel memo U.
Note:
• You must configure the antenna input source before
programming channels (L¢ page 29).
• Theautomaticchannelprogrammingprocesserases
channels that were previously programmed into the TV's
memory,
To tune the TV to a channel not programmed in the channel
memory, you must use the Channel Number buttons on the
remote control.
• Programming channels when the antenna input is
configured for Cable will take substantially longer than
when the antenna input is configured for Antenna This is
normal; however, once channel programming is finished,
you should not have to repeat the programming process
again unless your Cable TV service lineup changes
significantly,
To program channels automatically:
1 Configure the antenna input source, if you have not
aheady done so (_ page 29).
MENU
Press O and open the Setup menu.
3 Highlight Auto Oh Search.
4 Press _" or @ to begin channel programming (A new-set
of Auto Oh Search menu icons will appear its shown
below-.)
5
The TV will automaically cycle through all the antenna
channels, and store all active channels in the channel
memory. While the TV is cycling through the channels,
the message "Progress(%)" appears a white bar to
indicate the scanning status (as shown above).
To cancel channel programming, press E×[Toon the remote
control.
When channel programming is finished, press (_ or _ to
view the programmed channels.
Nanually addin9 channeJsinthe channeJ
memory
Auto Ch Search can search and save channel information
into the channel memory.
There are two ways to add channel information into the
channel memory if the program are not exist in Channel
memory previously:
(1)To add OnChSearch:
1 Press M_Uand open the Setup menu.
2 Highlight Add On Ch Search.
3 Press _ or @ to begin channel programming (A new-set
of Add On Ch Search menu icons will appear its below-.)
(2)Nanuafly to add channel on a physicaJchanneJ
For analog Channel:
2
Use the Channel Numbers to enter the channel number
that you want to add directly. (digital CH may use the
Dash (_ on the remote control, for example,56-1 )
Press (_ or _ on the remote control to save this adding
channel to Channel memory.
3O