Manual

• H-Position:
Moves the picture left/right.
The adjustment range is -50-+50 (default wdue is 0)2:
• V-Position:
Moves the picture up/down.
The adjustment range is -10-+10 (default value is 0).*
• Clock:
Helps to reduce noise and sharpen the pictmv.
The adjustment range is -10-+10 (default wdue is 0)2:
• Phase:
Helps to reduce noise and minimize periodic vertical
stripes on the screen.
The adjustment range is -15-+16 (default value is 0).*
_' The default settings may vary depending on the input signal
format.
Settin9 the PCAudio
If tile INPUT source is set to PC. Tile PC IN audio phone jack
is applied for PC IN when PC IN terminal is connecting with
an analog RGB cable. (t_ page 19)
Note: Because the PC Audio input is shared with HDMI 1.
If INPUT source is set to "HDMI 1,"And the HDMI 1 signal
is DVI format. This PC Audio input will apply for HDMI 1.
(Also see item 2 on page 11.)
Settin9 the sleep timer
You can set the sleep thner to turn off the TV after a set
length of time (maximum of 90 minutes).
To set the sleep timer using the remote control:
SLEEP
Press © on the remote control to set the length of trine until
the TV turns off. Repeatedly press SLEEP©to increase tile thne in
30-minute increments, to a maximum of 90 minutes.
To set the sleep timer using the on-screen memos:
1 Press M_uand open tile Prefer menu.
2 Highlight SleepTimer.
3 Press _" or@ to increase the trine in 30-minute
increments.
Off->30 Min->60 Min->90 Min->Off
Note: When a power failure occurs, the sleep timer setting
may be cleared.
To display the remaining sleep timer:
PIss SLEEP
e,',_ 0 on tile remote control or same as above process
using tile on-screen menus.
To cancel the sleep timer:
Repeatedly press SL_EVuntil it is set to Off.
41