Operation Manual

English - 15 -
English
Initial Installation
Before switching on the TV, put your decoder and media recorder to Standby if they are connected and
ensure the aerial is connected to your TV. To set up the TV, use the buttons on the remote control as
detailed on page 8.
IMPORTANT: Ensure that the aerial or cable is
connected and a Common Interface module is not
inserted before switching on the TV for the fi rst time
installation.
Connect the mains plug and switch the TV1. to on
using the side standby switch. If the TV does not
switch on, press any numbered or
button on
the remote control, then the language selection
menu will be displayed.
This screen will appear
the fi rst time that the TV is switched on and each
time the TV is reset.
By pressing 2. Up or Down button, highlight the
language you want to set and press OK button.
The following message will be displayed next:
By pressing 3. Left or Right button, select the
country you want to set and press Down button
to highlight Teletext Language option. Use
Left or Right button to select desired Teletext
Language.
Press 4. Down button after setting Teletext Language
option. Scan Encrypted will be then highlighted.
You can set Scan Encrypted as Yes if you want
to scan coded stations.
Press 5. OK button on the remote control to continue
and the following message will be displayed on
the screen:
Select 6. Yes button by using Left or Right button
and press OK button to continue. Afterwards, the
following OSD will be displayed on the screen:
If you select 7. Cable option, the following screen
will be displayed:
You can select frequency ranges from this 8.
screen. For highlighting lines you see, use Up or
Down button. You can enter the frequency range
manually by using the numeric buttons on the
remote control. Set Start and Stop Frequency as
desired by using numeric buttons on the remote
control. After this operation, you can set Search
Step as 8000 kHz or 1000 kHz. If you select
1000 kHz, the TV will perform search process
in a detailed way. Searching duration will thus
increase accordingly. When fi nished, press OK
button to start automatic search.
If you select 9. Aerial option from the Search Type
screen, the television will search for broadcasts.
The Auto tuning screen will appear and the 10.
television will start to search for available stations.
The progress bar will move along the line. You
must allow the television to complete the search.
The following OSD will be displayed on the
screen and the television will search for digital
and analogue TV broadcasts:
A01_32DL833_DVD_MB60_[GB]_(01-TV)_(IB_INTERNET)_DVB-TC_(1911UK).indd 15A01_32DL833_DVD_MB60_[GB]_(01-TV)_(IB_INTERNET)_DVB-TC_(1911UK).indd 15 10.10.2011 18:47:3910.10.2011 18:47:39