Operation Manual
23
CONTROLS AND FEATURES
Input selection and AV
connections
Defining the INPUT and OUTPUT sockets so that
the television recognises connected equipment.
See page 7 for a clear view of the back connection
recommendations.
Most media recorders and decoders send a signal through the
SCART lead to switch the television to the correct
Input
socket.
Alternatively press the external source selection button
o
until the picture from connected equipment is shown.
This button must be used to view equipment connected using
the COMPONENT VIDEO INPUT (
EXT3
) and the VIDEO INPUT
(
EXT4
).
An
S
in the display
e.g.
o
2S
(
EXT 2S
), indicates the input is set
for an S-Video signal.
Use the Input Selection if the television does not switch over
automatically.
a
At any time by pressing
o
a list will appear on screen
showing all stored programmes and external
equipment. Use
>
and
<
to highlight and
Q
to
select.
HDMI™ displays equipment connected to
Input HDMI
on the back of the television. It is designed for best
performance with 1080i high definition signals.
This specifies the type of signal going into SCART 2 (
EXT2
) on
the back of the television. Please refer to the manufacturers
instructions for the connected equipment.
a
In the
SET UP
menu press
<
until
AV connection
is
highlighted, then press
Q
.
b
With
Y
or
y
select either
AV
or
S-VIDEO
as the
required
input
for
EXT2
.
If the colour is missing try the alternative setting.
Input selection
1
HDMI1
4
3
2
TV
HDMI2
INPUT signal selection
SET UP
Language English
Country UK
Auto tuning
OK
Manual tuning
OK
AV connection
OK
Picture position
OK
MENU
Back
EXIT
Watch TV
MENU EXIT
AV connection
Back Watch TV
HDMI1 audio Digital
EXT2 input AV
00GB_AV500P_EngOM.book Page 23 Tuesday, December 11, 2007 5:40 AM