Operation Manual

24
CONTROLS AND FEATURES
If the connected HDMI source does not support digital audio,
plug the audio cable into
HDMI1 (AUDIO) on the back of the
television (as shown in the ‘Connecting an HDMI™ or DVI device
to the HDMI input’ section), then use the
HDMI1 audio
settings.
a In the SET UP menu press < until AV connection is
highlighted, then press
Q .
b In the AV connection menu press < to highlight
HDMI1 audio and using Y or y select Auto , Digital
or
Analogue .
If the sound is missing select an alternative setting.
NOTE: HDMI1 supports digital and analogue sound,
HDMI2 is digital sound only.
Certain formats of DVD disk may not output from this
TV (32/44.1/48kHz and 16/20/24 bits are
acceptable).
HDMI1 audio
OK
OK
OK
OK
MENU EXIT
SET UP
Language English
Country UK
Auto tuning
Manual tuning
AV connection
Picture position
Back Watch TV
MENU EXIT
AV connection
Back Watch TV
HDMI1 audio Digital
EXT2 input AV
HDMI, the HDMI logo, and High-Definition Multimedia Interface
are trademarks or registered trademarks of HDMI Licensing,
LLC.
00GB_AV500P_EngOM.book Page 24 Tuesday, December 11, 2007 5:40 AM