Operation Manual

English
30
CONTROLS AND FEATURES
HDMI1 audio
If the connected HDMI source does not support
digital audio, plug the audio cable into the phone
jack on the back of the television (as shown in
the ‘Connecting an HDMI™ or DVI device to the
HDMI input’ section), then use the HDMI1 audio
settings.
In the SET UP menu press ▼ until AV
connection is highlighted, then press
.
Language English
UK
OK
OK
OK
OK
OK
Country
Auto tuning
Manual tuning
AV connection
Quick Setup
Picture position
OK
Reset TV
SET UP
Watch TV
EXIT
Back
RETURN
In the AV connection menu highlight
HDMI audio and using ◄ or ► to select
Auto., Digital or Analogue.
HDMI1 audio
Lip Sync
EXT2 input
AV connection
On
Auto
S-VIDEO
Watch TV
EXIT
Back
RETURN
If the sound is missing select an alternative
setting.
NOTE: HDMI1 supports digital and analogue
sound, HDMI2 and HDMI3 is digital sound only.
Certain formats of DVD disk may not output from
this TV (32/44.1/48kHz and 16/20/24 bits are
acceptable).
HDMI, the HDMI logo, and High-Definition
Multimedia Interface are trademarks or registered
trademarks of HDMI Licensing, LLC.
INPUT signal selection
This specifies the type of signal going into
SCART (EXT1) on the back of the television.
Please refer to the manufacturers instructions for
the connected equipment.
In the SET UP menu press ▼ to select AV
connection, then press
.
Language English
UK
OK
OK
OK
OK
OK
Country
Auto tuning
Manual tuning
AV connection
Quick Setup
Picture position
OK
Reset TV
SET UP
Watch TV
EXIT
Back
RETURN
Model 19/22
Press ▲ or ▼ to select EXT1 input and ◄
or ► to select either AV or S-VIDEO as the
required input for EXT1.
HDMI audio
Lip Sync
EXT1 input
AV connection
On
Auto
S-VIDEO
Watch TV
EXIT
Back
RETURN
Model 26/32/37
Press ▲ or ▼ to select EXT2 input and ◄
or ► to select either AV or S-VIDEO as the
required input for EXT2.
HDMI1 audio
Lip Sync
EXT2 input
AV connection
On
Auto
S-VIDEO
Watch TV
EXIT
Back
RETURN
Check the signal output of the DVD or compatible
device first, generally the output type have AV,
S-Video, RGB for SCART.
When the input signal is S-Video or AV, please
select the correct setting for “Input” If the colour is
missing, please try alternative setting.
When the input signal is RGB, the colour will be
automatically detected and there is no need to
operate this setting.