Manual

DisplayingTVstatusinformation

To display TV status information using RECALL:

Press RECALL

The following information will display (if applicable):

• Current input (ANT, VIDEO 1, etc.)

• If ANT is the current input, either "CABLE" (for cable TV)

or "ANT" (for over-the-air broadcasts).

• Channel number (if in ANT mode)

• Channel label (if set)

• Digital signal strength indicator (bar graph in lower right

corner of box; for ATSC signal only)

• Stereo, Mono or SAP audio status (when HDMI input mode,

Dolby Digital or PCM)

• Video resolution

• Aspect ratio of incoming video signal (4:3 or 16:9)

• V-Chip rating status

To close the RECALL screen:

NN RECALL

Press © again.

To display TV status information using INFO:

Press _}_oon the remote control.

The following additional information will display for offair

digital channels (if applicable):

• Title

• Duration

• Detailed description

Note: The location of the banner can be moved to the top or

bottom of the screen by pressing A or V while the RECALL or

tNFO display is on-screen. (The last position will be stored to

memory.)

Understandingthe autopoweroff

feature

The TV will automatically turnitself off after approximately

15 minutes if it is tuned to a vacant channel or a station that

completes its broadcast for the day. This feature functions in

ANT mode only.

Understandingthe lastmode

memoryfeature

If the power is cut off while you are viewing the TV, the

Last Mode Memory feature automatically turns on the TV

when the power is resupplied.

Note: You should unplug the TV's power cord if it is possible

that you will be a way from the TV for an extended period of time

after the power is restored.