Manual

Connecting an audio system
This connection allows you to use an audio amplifier to adjust the
audio level. This also allows you to use external speakers.
To control the audio, turn on the TV and the stereo amplifier, and
turn off the built-in speakers (see "Turning off the built-in speakers"
on page 49).
You will need:
• one pair of audio cables
Note:
Tohearsoundwhenusinganexternalaudioamplifier,the
volumeof boththe7Vandtheamplifiermustbeset
above0 (zero).
Connecting an A/V receiver
This connection allows you to use an audio/video (A/V) receiver to
enhance your TV's sound.
If you have a system with Dolby Pro Logic®surround sound, you can
add to the realism of the sound by using the TV's internal speakers as
center channel speakers.
You will need:
• one pair of audio cables
• one single audio cable for the audio center channel
• one video cable
TV
Amplifier
Caution:
Toavoid damaging thespeakers, turn the TV
offbefore connecting or disconnectingthe
Audio Center Channel audio cable.
From Antenna
TV
Video TV Center
OUT IN OUT
\ I
I
To A/V Receiver
Note:
Referto the instructionsprovided with your A/V receiver
for detailsabout your surround soundsystem.
Whenthe Audio Center ChannelON/OFF switch is in
the ON position, the TVspeakers will function onlyas
center channelspeakers.
Adjust the volumefor the center channelspeakers
usingthe centerlevel control on theA/V receive_
Tousethe TVspeakersas normal speakers,set the
Audio Center Channel ON/OFF switch to the OFF
position.
Dolby Pro Logic* surround sound
system connection example
o I
L_aker_ r!T______ R_gh£e,
Surround r_ Surround
speaker L .._C speaker R
* Dolby Pro Logic is a registered trademark
of Dolby Laboratories Licensing
Corporation.
11