Manual

Adjusting the color convergence
This projection TV uses three separate TV tubes: red, green, and blue.
The red, green, and blue images are projected onto the screen where
they converge to form a full-color picture. You can see a clear picture
only when the three images converge correctly. Convergence may drift
over time or if you move the TV. If you can see clear images on your
TV screen, skip this procedure.
Make this adjustment after the TV has been on for at least 30
minutes.
TV Front Panel
MENU AV, I_ TouchFocus TM
TouchFocus TM auto convergence
"lb use the "lbuchFocus TM (auto convergence) button:
Press "lbuchFocus on the TV once. The TV will enter the auto
convergence mode and correctly adjust convergence
automatically.
TOUCHFOCUS
<.......... Horizontal
TOUCHFOCUS FIN I SHED
_B rig tfR
Vertica
When the adjustment is complete, the normal picture reappears.
If the error message "'lbuchFocus Error" appears, retry the
"lbuchFocus adjustment or adjust the convergence manually, as
described below.
"lb check and adjust the color convergence manually:
1. Press MENU, and then press _I or • until the PICTURE menu
appears.
2. Press • or • to highlight CONVERGENCE.
@@@@@@
PICTURE ANTENNA
MODE SPORTS
A
FLESH TONE ON
DNR OFF
CINEMA MODE FILM
COLOR
LIGHT RECALL POWER
___LE..... _...........
® ® @
®® ®
® ®
o ®o
O 0 O "0
(Continued on next page)
21