Operation Manual

17
CONNECTING YOUR TV
English
Setting up the USB HDD
To connect an USB HDD (not supplied)
NOTE: For available USB HDD information, see "Product Information" on the website.
To register an USB HDD
When you connect a new USB HDD to the USB 2 port on the
TV, the following screen will appear.
a Press C or c to select Yes and press OK.
The formatting confirmation window will appear.
b Press C or c to select Yes and press OK.
Registration will start.
c If you want to name the USB HDD, press C or c to
select Yes and press OK.
See page 53 to input characters.
The maximum number of characters is 10.
If you prefer the default name ”USB HDD X,” select No
and press OK.
d The Device List will appear.
You can now use registered USB HDDs.
While in the list mode, the following key operations
are available:
OK button................. To register/remove
RED button .............. To disconnect
GREEN button ........ To change Device Name
YELLOW button..... To test
BLUE button............ To format
NOTE:
• To disconnect a USB HDD from the TV, follow the
procedures for “To disconnect a USB HDD” section
(page 62).
• When using a USB HDD, if necessary, perform the settings
and operations shown in “Using the USB HDD Function”
section (see page 55).
• Connect the USB HDD to the USB 2 port.
Recording and playback cannot be performed if connected
to the USB 1 port.
• Up to 8 USB HDDs can be registered to this TV.
• Recorded programmes saved on the USB HDD can only be
viewed on this TV. They cannot be viewed when connected
to another TV (including the same model of TV), a PC, or
other device.
• If an HDD is re-registered, it will not be formatted.
• When the USB HDD is formatted, all the data stored on the
HDD will be deleted.
USB2
USB cable
(not supplied)
USB HDD
An unregistered USB HDD has been detected.
Register the USB HDD?
Yes
Device Name
Registered
Connected
USB HDD 1
USB HDD 2
USB HDD 3
Device List