Operation Manual

50
CONTROLS AND FEATURES
English
To cancel searching for the AP:
Press BACK while searching for the AP. A message will
appear; then, press C or c to select Yes and press
OK.
Assisted Setup
a In the Preferences menu, press B or b to select
Network Setup and press OK.
b Press B or b to select Wireless Setup and press OK.
c Press B or b to select Assisted Setup and press OK.
d Press B or b to select the desired AP and press OK.
NOTE: Check the MAC address on the label of the AP
or in the manual, and select your AP.
e Highlight Security Key and press OK. The Software
Keyboard window will appear.
f Input the Security Key by using the Software
Keyboard (see page 53). To save your setting, press
the BLUE button.
NOTE:
The Security Key must adhere to these conditions:
- TKIP/AES: 8-63 ASCII or 64 Hex characters
- WEP: 5 or 13 ASCII or 10 or 26 Hex characters
There is only one key ID to set for WEP encryption.
g Highlight Done and press OK.
NOTE: If Network Name is not displayed, see step 4
and 5 in Manual Setup below to set Network Name
before pressing Done.
NOTE: Settings are not saved if BACK is pressed before Done
is selected.
Manual Setup
a In the Preferences menu, press B or b to select
Network Setup and press OK.
b Press B or b to select Wireless Setup and press OK.
c Press B or b to select Manual Setup and press OK.
d Press B or b to select Network Name and press OK.
The Software Keyboard window will appear.
e Input the Network Name by using the Software
Keyboard (see page 53). To save your setting, press
the BLUE button.
f Press B or b to select Authentication and press C or
c to select Open System, Shared Key, WPA-PSK or
WPA2-PSK.
g Press B or b to select Encryption and press C or c
to select None, WEP, TKIP or AES.
NOTE:
Certain encryption types are only compatible with
specific authentication types.
- When Authentication is Open System, only WEP
or None is compatible.
- When Authentication is Shared Key, only WEP is
compatible.
- When Authentication is WPA-PSK or WPA2-PSK,
only TKIP or AES is compatible.
When incompatible Authentication/Encryption
pairings are detected, a warning message will be
displayed, and no connection attempt will be made
until the incompatibility is resolved.
There is only one key ID to set for WEP encryption.
h Press B or b to select Security Key and press OK.
i Input the Security Key by using the Software
Keyboard (see page 53). To save your setting, press
the BLUE button.
NOTE: This item is grayed out when Encryption is
None.
j Highlight Done and press OK.
NOTE: When Encryption is None, a message will
appear. Press
C or c to select Yes and press OK.
NOTE: Settings are not saved if BACK is pressed before Done
is selected.
Enhanced 11n
When Enhanced 11n is set to On, the Dual Channel (40MHz)
feature is available.
NOTE: In addition, some other optional 11n features will be
enabled.
a In the Preferences menu, press B or b to select
Network Setup and press OK. Highlight Wireless
Setup and press OK.
b Press B or b to select Enhanced 11n and press C or
c to select On.