Manual

Connecting an audio system
This connection allows you to use an audio amplifier to adjust the
audio level. This also allows you to use external speakers.
"lb control the audio, turn on the TV and the stereo amplifier, and
turn off the built-in speakers (see "'lhrning off the built-in speakers"
on page 47).
You will need:
• one pair of audio cables
Note:
Tohear sound whenusing an externalaudio amplifier,the
volume of both the TVand the arnp/ifiermust be set
above0 Czero).
For example,ff the volume of the TVisset to O,you will
not be able to hear anysound, eventhe volumeof the
arnp/ifieris"at its"highest level.
Connecting an A/V receiver
This connection allows you to use an audio/video (A/V) receiver to
enhance your TV's sound.
If you have a system with Dolby Pro Logic ®surround sound, you can
add to the realism of the sound by using the TV's internal speakers as
center channel speakers.
You will need:
• one pair of audio cables
• one single audio cable for the audio center channel
• one video cable
To A/V Receiver
I
/ \
Video TV Center From
OUT IN OUT Antenna
TV
Note:
Refer to the instructionsprovided withyour A/V receiver
for details"aboutyour surround sound system.
When theAudio Center ChannelON/OFF switch is"in
the ON position, the TVspeakerswill function only as
center channelspeakers.
Adjust the volumefor the center channelspeakers"
usingthe center level control on theA/V receiveL
Tousethe TVspeakers"as normal speakers,set the
Audio Center ChannelON/OFF switch to the OFF
position.
Amplifier
TV
Caution:
Toavoid damaging the speakers,turn the TV
off beforeconnecting or disconnectingthe
Audio Center Channelaudio cable.
Dolby Pro Logic* surround sound
system connection example
:_ a i :_'_
_peaker_ '_' _speake
Surround _ Surround
speaker L .._L speaker R
* Dolby Pro Logic is a registered trademark
of Dolby Laboratories Licensing
Corporation.
11