Manual

Adding channels to the TV's memory
When you press Channel • or V, your TV will select only the
channels stored in the TV's channel memory.
Follow the steps below and on the next page to program all active
channels into the TV's memory.
Programming channels automatically
Your TV can automatically detect all active channels in your area and
store them in its memory. After the channels are stored automatically,
you can manually add or erase individual channels (see page 20).
If you use both ANT-1 and ANT-2 terminals, you must program
channels for each input source.
"lb program channels automatically:
1. Press MENU, and then press _ or • until the SET UP menu
appears.
2. Press • or • until TV/CABLE is highlighted.
3. Press _ or • to highlight either TV or (]ABLE, depending on
which you use. If you use an antenna, highlight TV; if you use
cable, highlight (]ABLE.
@@@©@@
SET UP
LANGUAGE ENGLISH
CLOCK SET 00:00
CH PROGRAM _ •
ADD/ERASE ADD
Note:
Totune the TV to a channel not programmed
in the channel memory, use the Channel
Number buttons on the remote control.
®®@
-- Channel AV
Channel
Numbers
MENU
4. Press • to select CH PROGRAM.
@@@@@@
SET UP
LANGUAGE ENGL ISH
CLOCK SET 00:00
ANT1/2 ANTI
ADD/ERASE ADD
5. Press _ or • to start channel programming. The TV will
automatically cycle through all the TV or Cable channels
(depending on which you selected), and store all active channels
in the channel memory.
While the TV is cycling through the channels, the message
"Programming Now--Please Wait" appears.
6. When channel programming is complete, the message
"Completed" appears.
7. Press Channel • or • to view the programmed channels.
19