Manual

Adjusting the color convergence
This projection TV uses three separate TV tubes: red, green, and blue.
The red, green, and blue images are projected onto the screen where
they converge to form a full-color picture. You can see a dear picture
only when the three images converge correctly. Convergence can drift
over time or if you move the TV. If you can see clear images on your
TV screen, skip this procedure.
Make this adjustment only after the TV has been on for at least 30
minutes.
To check and adjust the color convergence:
1. Press MENU, and then press • or • until the PICTURE menu
appears.
2. Press • or • to highlight CONVERGENCE.
@@®@@@
PICTURE ANTENNA
MODE SPORTS
FLESH TONE ON
NOI SE REDUCTION OFF
COLOR
LIGHT RECALL POWER
C_LE MUTET_,oEo_,ME_
NO ©
-- Number
MENU
ENTER
EXIT
3. Press • or • to display the center convergence menu.
t
m BLUE
ENTER:TO SELECT COLOR
EXiT :TO SELECT POSITION
If you see separate color lines (red, blue, and green or white), you
need to adjust the convergence.
4. Press ENTER to highlight RED or BLUE.
5. Press • (up), • (down), • (left), or • (right) to converge the red
or blue line into the green (or white) line. When the convergence
is adjusted correctly, you will see two single, crossed white lines.
6. Press EXIT to display the circumference convergence menu.
7. Press the corresponding Number button (1-4 and 6-9) to select
the area of the screen you want to adjust.
8. Press ENTER to highlight RED or BLUE.
4-
+
RED r_
ENTER:TO SELECT COLOR
EXiT :TO SELECT POSITION
9. Press ••• • to converge the red or blue line into the green (or
white) line.
Repeat steps 8 and 9 until you see two single, crossed white lines.
10. Press EXIT once to select another area to adjust in the
circumference convergence menu, and then repeat steps 7-9.
11. Press EXIT twice to close the convergence menus.