Manual

Adding channels to the TV's memory
When you press Channel • or V, your TV will stop only on the
channels stored in the TV's channel memory.
Follow the steps below and on the next page to program all active
channels into the TV's memory.
Programming channels automatically
Your TV can automatically detect all active channels in your area and
store them in its memory. After the channels are stored automatically,
you can manually add or erase individual channels (see page 29).
To program channels automatically:
1. Press MENU, and then press _1or • until the SET UP menu
appears.
2. Press • or • until TV/CABLE is highlighted.
3. Press 4 or • to highlight either TV or (:ABLE, &pending on
which you use. If you use an antenna, highlight TV; if you use
cable, highlight (:ABLE.
O SET UP
LANGUAGE ENGL _ SH
CLOCK SET OO:00
....ANTI g a .... _N7 f,
GH pROGRAM
ADD/ERASE ADD
QUICK CONNEOT GUIDE _"
4. Press • to select CH PROGRAM.
Note:
Totune the TVto a channel nogpr_,grammed
/r_the channelmemory,,you must use the
ChannelNumber buttons on the remote
oorltrbL
:°vD _ taCT
03®®
® ®
- E.O
-....
| Channel &V
_SET OP
LANGUAGE ENGLISH
CLOCK SET 00:00
ANTI/2 ANTI
_ADD/ERASE ADD
QUICK CONNECT GUIDE _
5. Press _1or • to start channel programming. The TV will
automatically cycle through all the TV or Cable channels
(depending on which you selected), and store all active channels
in the channel memory.
While the TV is cycling through the channels, the message
"Programming Now--Please \V_ait"appears.
6. When channel programming is complete,the message
"Completed" appears.
7. Press Channel • or • to view the programmed channels.