- TOSHIBA Satellite A10 Series Portable Personal Computer User's Manual
Table Of Contents
- Personal Computer
- Table of Contents
- Preface
- General Precautions
- Chapters
- Chapter 1 Introduction
- Chapter 2 The Grand Tour
- Chapter 3 Getting Started
- Chapter 4 Operating Basics
- Chapter 5 The Keyboard
- Chapter 6 Power and Power-Up Modes
- Chapter 7 HW Setup and Passwords
- Chapter 8 Optional Devices
- Chapter 9 Troubleshooting
- Appendixes
- Glossary
- Index
![](/manual/toshiba/a10-series/toshiba-satellite-a10-series-portable-personal-computer-users-manual/images/img-191.png)
C-7
A
PPENDIX
C
X5 Enable Enable OK, RING, NO CARRIER, ERROR,
NODIALTONE, BUSY, CONNECT
<RATE>, RRING, NO BONGTONE,
DELAYED, BLACKLISTED, REORDER,
WARBLE, CALL WAITING DETECTED
Dial tone detect
Disabled: The modem dials a call regardless of whether it detects a
dial tone.
Enabled: The modem dials only upon detection of a dial tone, and
disconnects the call if the dial tone is not detected within
10 seconds.
Busy tone detect
Disabled: The modem ignores any busy tones it receives.
Enabled: The modem monitors for busy tones.
Result Codes:
OK n=0,1,2,3,4,5
ERROR Otherwise
Zn Recall stored profile
The modem performs a soft reset and restores (recalls) the configura-
tion profile according to the parameter supplied. If no parameter is
specified, zero is assumed. Either Z0 or Z1 restores the profile.
Result Codes:
OK n=0,1
ERROR Otherwise
&Cn Data Carrier Detect (DCD) control
Data Carrier Detect is a signal from the modem to the computer
indicating that a carrier signal is being received from a remote modem.
DCD normally turns off when the modem no longer detects the carrier
signal.
Appendix C