- TOSHIBA Satellite A10 Series Portable Personal Computer User's Manual
Table Of Contents
- Personal Computer
- Table of Contents
- Preface
- General Precautions
- Chapters
- Chapter 1 Introduction
- Chapter 2 The Grand Tour
- Chapter 3 Getting Started
- Chapter 4 Operating Basics
- Chapter 5 The Keyboard
- Chapter 6 Power and Power-Up Modes
- Chapter 7 HW Setup and Passwords
- Chapter 8 Optional Devices
- Chapter 9 Troubleshooting
- Appendixes
- Glossary
- Index
3 The standard connecting arrangement (telephone jack type) for this equipment is
jack type(s): USOC RJ11C.
The IC registration number of the modem is shown below.
Canada: 1353A-L4AINT
Notes for Users in Australia and New Zealand
Modem warning notice for Australia
Modems connected to the Australian telecoms network must have a valid Austel
permit. This modem has been designed to specifically configure to ensure compli-
ance with Austel standards when the country/region selection is set to Australia.
The use of other country/region setting while the modem is attached to the
Australian PSTN would result in you modem being operated in a non-compliant
manner. To verify that the country/region is correctly set, enter the command ATI
which displays the currently active setting.
To set the country/region permanently to Australia, enter the following command
sequence:
AT%TE=1
ATS133=1
AT&F
AT&W
AT%TE=0
ATZ
Failure to set the modem to the Australia country/region setting as shown above
will result in the modem being operated in a non-compliant manner. Consequently,
there would be no permit in force for this equipment and the Telecoms Act 1991
prescribes a penalty of $12,000 for the connection of non-permitted equipment.