user manual

 Install the remote controller
NOTE
Lite-Vision plus Remote Controller
Installation Manual
• Wiring for the remote controller should not be bundled or installed in the same conduit with a power cable.; otherwise,
malfunction may result.
• Install the remote controller away from sources of electrical interference and electromagnetic fields.
1 Insert a flat-blade screwdriver into the groove on the back side of the remote controller to remove
the rear case.
2 Use the wood screws (2 pieces) supplied with the remote controller to attach the rear case of the
remote controller to the wall. Do not use an electrical screwdriver
. Do not over-tighten the screw (Tightening torque is up to 2
kg / f•cm.); otherwise, the rear case may be damaged.
3 Connect the electrical wire from the indoor unit to the terminal block of remote controller.
(Refer to “Wire the remote controller”.) Check the terminal number of electrical wire from the indoor unit to avoid miswiring.
(If AC 200-240 V is applied, the remote controlle
r and indoor unit will break down.)
Rear case
Remote controller
Wood screw x 2
<Back side of the remote controller>
Lite-Vision plus Remote Controller
Installation Manual
 Wire the remote controller Wiring diagram Terminal block for the remote control wiring on the indoor unit  Requirements for wiring of group control • To make wiring of group control for indoor units of 4-way cassette type and other types, set the 4-way cassette
type as the header unit; otherwise, some settings such as the individual louver setting are not available.
• To make wiring of group control for the indoor unit with the
automatic grille-up / down function and the one without
the function, set the indoor unit with the automatic grille-up / down function as the header unit; otherwise, the automatic grille-up / down function is not available.
 Requirements for installing two remote controllers In the dual remote controller system, one or more units are operated from two remote controllers. (Up to two remote controllers can be installed.) Set the follower remote controller Set from “6. Header/follower” in “10. Initial setting” on the MENU screen. For details, refer to the page 16. Install the remote controllers For the dual remote controller system, install the remote controllers as follows: 1 Set one remote controller as the header remote controller.
(The remote controllers are set as “Header r
emote controller” as factory default.)
2 When the dual remote controller system is installed by using this remote controller (RBC-
AMS51E-ES, RBC-AMS51E-EN) with the other type of remote controller, set this remote controller as the header remote controller.
Remote control wiring (procured locally)
Terminal block for the remote control wiring
Remote controller
* Terminals of A and B
have no polarity.
* Use wire of 0.5 mm
2
to 2.0 mm
2
.
* A crimp-style terminal cannot be used.
FILE NO. SVM-12004
– 100 –