user manual

Basic wiring diagram
NOTE
Lite-Vision plus Remote Controller
Installation Manual
Terminals of A and B have no polarity.
To diverge from the indoor unit To diverge from the header remote controller
To operate a group control of multiple indoo
r units by two remote controllers
* The header or follower remote controller can be connected to any indoor unit.
Remote control wiring (Locally procured) 0.5 mm
2
to 2.0 mm
2
.
Remote controller
(header)
Remote controller
(follower)
(Sold separately)
Terminal block
for the remote
control wiring
Earth
Indoor unit
Remote control wiring (Locally procured) 0.5 mm
2
to 1.25 mm
2
.
Remote controller
(header)
Remote controller
(follower)
(Sold separately)
Terminal block
for the remote
control wiring
Earth
Indoor unit
Remote controller inter-unit wires for group control (Locally procured)
Remote controller
(header)
Remote controller
(follower)
(Sold separately)
Terminal block for the
remote control wiring
Earth
Indoor unit
No.1
Earth
Earth
Earth
Indoor unit
No.2
Indoor unit
No.3
Indoor unit
No.8
Lite-Vision plus Remote Controller
Installation Manual
 For first use It takes some time before the remote controller becomes operable when the remote controller is used for the first time. This is not a malfunction. <When the power is turned on for the first t
ime after installation>
It takes about 5 minutes before the remote controller becomes operable. <When the power is turned on from the second time> It takes about 1 minute before the remote controller becomes operable.  Note For the operation of switching the room temperature sensor or the settings of the test operation, refer to the page 19.
Power on
“ ” flashes
“”
disappears
Remote controller becomes
operable.
About 5
minutes
Power on
“ ” flashes
“”
disappears
Remote controller becomes
operable.
About 1
minute
FILE NO. SVM-12004
– 101 –