Instruction Manual

E6581541②
3. Installing the APG001Z
Install the APOGEE
®
FLN option to VF-PS1 as follows.
Mandatory
Turn off the input power of VF-PS1 and wait for at least 15 minutes and then check
that the CHARGE lamp on VF-PS1 is no longer lit.
(1) Turn off input power of VF-PS1 and wait for at least 15 minutes and then check
that the CHARGE lamp on VF-PS1 is no longer lit.
(2) Securing the option to the inverter
a) Insert a flat-blade screwdriver in each of the two holes at the upper part of the
front panel, release the panel mounting tab by pushing the screwdriver down and
remove the front panel cover.
b) Install the option in the inverter by fitting the tabs on the lower side the option into
the slots at the lower part of the inverter front panel.
c) Make sure the option is securely attached to the inverter. Then check whether the
plastic bosses on the inverter case have fitted in the holes at the upper and lower
parts of the option.
d) Insert the tabs at the lower part of the front cover into the slots at the lower part of
the inverter to attach the front cover to the inverter.
e) Stuck the enclosed "LED name label" in the option LED display part of a front
cover.
a)
b)
c)
d)
e)
LED name label
COM
ERR
400V 90 KW –630KW
VF-PS1 200V 55KW –90KW
Remove a standard equipped option
case, in case of below type of inverter.
- 8 -