Printer User Manual

- 133 -
Explanation (1) Number of labels to be issued
c If increment/decrement is not specified, the designated number of pieces with
the same drawing data will be issued.
d If increment /decrement is specified, the designated number of pieces will be
issued while incrementing/decrementing the piece of the designated drawing
area.
* The increment/decrement designation is valid until the Image Buffer Clear
Command ([ESC] C) is transmitted.
If no subsequent command is received from the PC for 1 second after issuing the
last label, when automatic forward feed standby is set to “ON” in the system mode,
the printer automatically performs a 19-mm forward feed.
When the Issue Command is received during the automatic forward feed standby,
an issue is started after a reverse feed to the original position.
If any command is sent and processed after the Issue Command is sent, the
automatic forward feed is not performed. Therefore, a command should not be
sent after the Issue Command is sent. The power should not be turned off then
on, or the printer should not be placed in a pause/reset state before the automatic
forward feed, since the automatic forward feed is not performed when the paper is
fed by turning the power off then on, or by pressing the [FEED] key of the printer in
the pause/reset state.
If the paper is fed by pressing the [FEED] key of the printer during the forward feed
standby, the printer feeds one label, performs the automatic forward feed, then
stops.
(2) Cut interval
The cut interval is valid only when the cutter has been installed and the issue mode
is “C”. If an error occurs during an issue after the cut interval is designated, and
then printing is restarted, the printer ejects the printed paper, then resumes
printing on the paper where the error occurred.
(3) Type of sensor
c No sensor: Printing takes place according to the parameter designated by the
Label Size Set Command.
d Lower reflective sensor:
Printing takes place according to the parameter designated by the Label Size
Set Command. However, the black mark provided on the back of the tag
paper is automatically sensed by the lower reflective sensor and the paper
position is finely adjusted for every piece.
e Transmissive sensor (when using normal labels):
Printing takes place according to the parameter designated by the Label Size
Set Command. However, the label-to-label gap is automatically sensed by the
transmissive sensor and the paper position is finely adjusted for every piece.
f Transmissive sensor (when using preprinted labels):
Printing takes place according to the parameter designated by the Label Size
Set Command. However, the label-to-label gap is automatically sensed by the
transmissive sensor and the paper position is finely adjusted for every piece,
according to the value set by the threshold setting operation (key operation).