Printer User Manual

- 143 -
f Transmissive sensor (when using preprinted labels):
Feeding takes place according to the parameter designated by the Label Size
Set Command. However, the label-to-label gap is automatically sensed by the
transmissive sensor and the stop position is finely adjusted according to the
value set by the threshold set operation (key operation).
g Lower reflective sensor (when using a manual threshold value)
Feeding takes place according to the parameters designated by the Label Size
Set Command. However, the black mark provided on the back of the tag
paper is automatically sensed by the lower reflective sensor and the paper
position is finely adjusted for every piece, according to the value set by the
threshold set operation (key operation).
h Upper reflective sensor (for detecting black marks on the print side of label):
Feeding takes place according to the parameter designated by the Label Size
Set Command. However, the black mark provided on the print side of the tag
paper is automatically sensed by the upper reflective sensor and the paper
position is finely adjusted for every piece.
i Lower reflective sensor (for detecting marginal punched holes on the fanfold
paper):
Feeding takes place according to the parameter designated by the Label Size
Set Command. However, the marginal punched holes (round holes) on the
fanfold paper are automatically sensed by the lower reflective sensor. Several
round holes are automatically sensed according to the specified pitch length of
label, and the paper position is finely adjusted for every piece.
(2) Cut/non-cut
This option is valid in batch feed mode only. (Non-cut is selected in the strip mode
for the auto labeler.)