Printer User Manual

- 145 -
[D or E: Strip mode for auto labeler]
NOTE: To perform the strip issue for the auto labeler, the backing paper
rewind system and the control unit are required on the auto labeler as
external equipment.
(4) Feed speed
• A feed is performed at the designated speed.
However, the back feed speed in the cut mode or the strip mode for the auto
labeler is 2”/sec.
• The possible feed speed varies according to types and sizes of the paper
supply. For details, refer to the Supply Specification.
Parameter Feed speed
1 2”/sec
2
3
4
5
6 4”/sec
7
8
9
A
(5) With/without ribbon
Without ribbon: The ribbon motor is not operated at feed.
With ribbon: The ribbon motor is operated at feed.
(6) If no subsequent command is received from the PC for 1 second after feeding
labels, when automatic forward feed standby is set to “ON” in the system mode,
the printer automatically performs a 19-mm forward feed. When the Feed
Command is received during the automatic forward feed standby, a feed is started
after a reverse feed to the original position.
* For notes, refer to the section regarding the Issue Command.
Head positionStrip position
(1) Place paper.
(2) Feeds back to the home position.
(3) Feeding starts
(4) End of feed
(Completes feeding to the top of form and stops)