Printer User Manual

- 146 -
Notes (1) If a change of label size or type of sensor, feed fine adjustment, cut position fine
adjustment (or strip position fine adjustment) or back feed fine adjustment is
made, one label must be fed to adjust the first print position prior to printing.
(2) The parameter of the Feed Command is protected in memory (even if the power is
turned off).
(3) When “status response made” is selected in the Issue Command parameter
setting, a status response is made after the end of feed or when an error occurs.
(4) For explanation about the process to stop the label at the home position, refer to
the section regarding the Issue Command.
(5) If no subsequent command is received from the PC for 1 second after the last
label has been fed, the printer automatically performs a 19-mm forward feed when
the cut mode is selected and “with automatic forward feed standby” is selected in
the system mode. When the Feed Command is received during the forward feed
standby, the printer feeds the label in reverse to the original position and ejects it.
* For notes, refer to the section regarding the Issue Command.
Examples
[ESC] D0762, 0820, 0732 [LF] [NUL]
[ESC] AX; +010, +000, +10 [LF] [NUL]
[ESC] T11C40 [LF] [NUL]
[ESC] C [LF] [NUL]
[ESC] PC001; 0150, 0410, 1, 1, A, 00, B [LF] [NUL]
[ESC] RC001; Sample [LF] [NUL]
[ESC] XS; I, 0004, 0011C4001 [LF] [NUL]
76.2 mm
S a m p l e
41.0
mm
73.2
mm
15.0 mm
82.0 mm
Paper feed direction