Printer User Manual

- 164 -
Notes (1) No matter what character set or character code is selected, no memory will be
wasted.
(2) When a new writable character is stored, the Flash Memory Card Format
Command ([ESC] J1) or the ATA Card Format Command ([ESC] JA) must be
transmitted.
(3) A character code already stored can be stored in the flash memory card again if
the Bit Map Writable Character Command ([ESC] XD) is transmitted, but memory
will be consumed with every storage. Memory can be efficiently used by sending
the Memory Card Format Command ([ESC] J1) before storing.
(4) If a flash memory card is used, and a label issue operation is performed after
sending the Bit Map Writable Character Command ([ESC] XD), the image buffer is
automatically cleared.
(5) When the storing operation stops after storing the writable character and logos, the
printer automatically enters the online mode (label issue operation) after about 10
seconds. In this case, when the flash memory card is used, the image buffer is
automatically cleared.
(6) Only a 4-MB flash memory card manufactured by Maxell can be used for storing a
writable character.
Refer to Memory Card Format Command (for flash memory card) ([ESC] J1)
Memory Card Format Command (for ATA card) ([ESC] JA)