Printer User Manual

- 190 -
f: RS-232C transmission control
0: XON/XOFF protocol
(No XON output when the power is turned on, no XOFF output when the
power is turned OFF)
1: READY/BUSY (DTR) protocol
(No XON output when the power is turned on, no XOFF output when the
power is turned OFF)
2: XON/XOFF + READY/BUSY (DTR) protocol:
(XON output when the power is turned on, XOFF output when the power is
turned OFF)
3: XON/XOFF protocol:
(XON output when the power is turned on, XOFF output when the power is
turned OFF)
4: RTS protocol
(No XON output when the power is turned on, no XOFF output when the
power is turned OFF)
g: Language for LCD messages
0: ENGLISH
1: GERMAN
2: FRENCH
3: DUTCH
4: SPANISH
5: JAPANESE
6: ITALIAN
h: Forward feed standby after an issue
0: OFF (Not performed)
1: ON (Performed)
i: Indicates the direction in which the fine adjustment of the stop position of forward
feed is to be made.
+: Performs the forward feed with the length longer than the current value
-: Performs the forward feed with the length shorter than the current value
jj: Fine adjustment value for the stop position of the forward feed
00 to 50 (in units of 0.1 mm)
*1
k: Type of control code
0: Automatic selection
1: ESC, LF, NUL mode
2: {, |, } mode
3: Any set code
ll: 1st byte code of the control code
*2
“00” to “FF” (Specify the hex code in 2 bytes of ASCII code)
*3
mm: 2nd byte code of the control code
*2
“00” to “FF” (Specify the hex code in 2 bytes of ASCII code)
*3
nn: 3rd byte code of the control code
*2
“00” to “FF” (Specify the hex code in 2 bytes of ASCII code)
*3