Printer User Manual

- 191 -
o: [FEED] key function
0: FEED: Feeds one label.
1: PRINT: Prints data of image buffer on one label.
p: Kanji code selection
0: TYPE 1
1: TYPE 2
qq: Euro code setting
“20” to “FF” (Specify the hex code in 2 bytes of ASCII code)
*3
r: Automatic head broken dots check
0: OFF (When the power is turned on, the broken dots check is not
automatically performed.)
1: ON (When the power is turned on, the broken dots check is automatically
performed.)
s: Centronics ACK/BUSY timing setting
0: TYPE1
1: TYPE2
t: Web printer function setting
0: OFF (Web printer function is disabled.)
1: ON (Web printer function is enabled.)
u: Silent printing function setting
1: ON Silent printing function is enabled.)
v: Keyboard (KB-80) connection setting
0: OFF (The KB-80 is not connected.)
1: ON (The KB-80 is connected.)
Explanation (1) This command is not executed until the printer enters an idle state.
(2) Except for some of them, the parameters set by this command become effective
when the power is turned on or the Reset Command is sent.
*1: The value can be set in units of 0.1 mm. However, the value which is actually set
on the printer, is in units of 0.5 mm. When a value from 0.0 mm to 0.4 mm is set, it
is actually set on the printer as 0.0 mm. Also when a value from 0.5 mm to 0.9 mm
is set, it is actually set on the printer as 0.5 mm.
This fine adjustment value is set on the printer only when the automatic forward
feed standby after an issue is set to “ON”. If it is set to “OFF”, this value is
discarded.
*2: This value is set on the printer only when “Any set code” is selected for the control
code. If any value than “Any set code” is set, it is discarded.
*3: Specify the hex code to be set in 2 bytes of ASCII code as shown below:
Example 1: To set 36H: ”36” (33H, 36H)
Example 2: To set 42H: ”42” (34H, 32H)
Example 3: To set FFH: ”FF” (46H, 46H)