Printer User Manual

- 197 -
(3) Label End
c When the transmissive sensor and lower reflective sensor detect the label end state in 3 mm
continuously, an error will result.
d If the transmissive sensor and lower reflective sensor detect the label end state when an issue,
feed, and ejection are attempted in a printer stop state, an error will result.
(4) Head Open Error
c If the head open sensor detects the open state in 5 mm continuously, an error will result.
d If the head open sensor detects the open state when an issue, feed, and ejection are
attempted in a printer stop state, an error will result.
However, the feeding by the [FEED] key on the printer and the issuing and feeding by the
expansion I/O, are not included.
(5) Thermal Head Error
c A broken dot error has occurred in the thermal head.
d An error has occurred in the thermal head driver.
(6) Thermal Head Excessive Temperature
c When the open-air temperature detection thermistor detects an excessively high temperature,
an error will result.
d When the thermal head temperature detection thermistor detects an excessively high
temperature, an error will result.
e When the heat sink sensor detects an excessively high temperature, an error will result.
f In the direct thermal printing, if the thermal head temperature detection thermistor detects
more than 65°C, the printer completes printing, then stops until the temperature becomes 65
°C or lower.
(7) Ribbon Error
When the ribbon is specified, and the motor speed calculated from the ribbon motor sensors
(rewind/back tension) and rotation direction are out of specification, an error will result.
c Rotation of the ribbon motor (rewind) is too fast.
e Rotation of the ribbon motor (rewind) is too slow, or the ribbon motor does not rotate.
e The ribbon motor (back tension) does not rotate.
f The ribbon motor (back tension) rotates in the reverse direction.
• The ribbon is not installed.
• A ribbon jam has occurred.
• The ribbon has been torn.
• An abnormal condition has occurred in the ribbon motor sensor.
• The ribbon has run out.
* At the moment an error occurs, the printer displays the error message, makes a status
response, then stops. Only the Status Request Command and Reset Command can be
processed, and other commands are not processed. Restoration using the [RESTART] key is
possible except in the case of a thermal head excessive temperature error. (The printer
resumes printing the label where the error occurred.)