Printer User Manual

- 200 -
9.1.3 Detail Status
Detail Status
LCD Message Printer Status
Auto Status Status Request
Transmission Command
ON LINE
The head was closed with the head open. 00 00
HEAD OPEN
The head was opened in the online mode. 01 01
ON LINE ****
Operating (Analyzing command, drawing,
printing, or feeding)
–02
PAUSE ****
In a pause state – 04
Display of error message
A command error was found in analyzing the
command.
06 06
COMMS ERROR
A parity error, overrun error, or framing error
occurred during communication by RS-232C
07 07
PAPER JAM ****
A paper jam occurred during paper feed. 11 11
CUTTER ERROR****
An abnormal condition occurred at the cutter. 12 12
NO PAPER ****
The label has run out. 13 13
HEAD OPEN ****
An attempt was made to feed or issue with the
head open. (except the [FEED] key)
15 15
HEAD ERROR ****
A broken dot error has occurred in the thermal
head.
17 17
EXCESS HEAD TEMP
The thermal head temperature has become
excessively high.
18 18
RIBBON ERROR****
An abnormal condition occurred in the sensor
for determining the torque for the ribbon motor.
The ribbon has run out.
21 21
ON LINE
The issue has been completed normally. 40 –
ON LINE
The feed has been completed normally. 41 –
SAVING ### &&&&
In writable character or
–55
SAVING %%%%%%%
PC command save mode
FLASH WRITE ERR.
An error has occurred in writing data
into the flash memory card.
50 50
FORMAT ERROR
An erase error has occurred in
formatting the flash memory card.
51 51
FLASH CARD FULL
Saving failed because of the
insufficient capacity of the flash
memory card.
54 54
Display of error message
(See Note 1.)
A command error has occurred in
analyzing the command.
06 06
COMMS ERROR
A parity error, overrun error, or framing
error has occurred during
communication by RS-232C.
07 07
Writable
character,
PC command,
save mode