Printer User Manual

- 38 -

[Fine Adjustment of Stop Position of Strip Issue]

• Printing in the strip issue mode for the auto labeler stops at the

position where the distance from the middle point of the label-to-

label gap to the end of the strip shaft is 4 mm, since the label-to-

label gap is assumed to be 2 mm.

• When the print stop position is not proper, the print stop position

should be adjusted using the fine adjustment function of the

stop position of the strip issue.

• When the label-to-label gap is 5 mm or more, the effective print

length should be set to the maximum (label pitch -2 mm). Then,

the print stop position should be adjusted using the fine

adjustment function of the stop position of the strip issue.

[Back Feed Fine Adjustment] (To finely adjust the back feed for shifting backward or forward)

0.0 mm

+3.0 mm

-3.0 mm

0.0 mm

+3.0 mm

First print position (home position after back feed)

- 3.0 mm

Paper feed direction

2 mm

3 mm

4 mm