User's Manual

33
Getting Started
Starting again from the power save mode
Under normal conditions, while replacing the battery, the internal
battery will maintain the date and time settings. However, there is a
small chance the settings may be lost (the internal battery backup
will last for approximately seven days). It is recommended to check
that the date and time settings are still correct after replacing the
battery and before taking photos or recording of any type.
Resetting the date and time
1 Press the Power button for approximately one second to turn on
the camcorder.
2 Press the MENU button.
3 Select CLOCK SET and press the OK button.
The Clock Set screen appears.
4 Use the Up/Down arrow buttons to toggle between selections
and assign a value to each.
Starting again from the power save mode
In order to preserve battery power, the power save (sleep) function
will automatically turn off the camcorder after approximately one
minute of inactivity while taking photos or videos, or about five
minutes of inactivity while in playback mode. This setting is
factory-preset.
❖ You can restore the power by pressing the Power button.
❖ The camcorder turns off after approximately twelve hours, if
connected to a computer or printer.
If the ( ) icon appears...
❖ When a photo is taken, the date and time it was captured are
recorded with it. If the date and time settings have not been
completed, the date and time cannot be recorded with the
captured images. For this reason, immediately after the
camcorder is turned on, the “Set date and time” reminder briefly
appears, after which the ( ) icon is shown on the Recording
Screen. To have the date and time recorded with the images,
please complete this setting before capturing images.
NOTE