Manual

5
Section 2
Getting Up and Running
 Loading the Battery
Before using the camera, end users must load
NP60 rechargeable Li-ion Battery.
1. Follow the arrow direction and slide to eject the
battery cover.
2. Insert the batteries according to the correct
polarity marks ( + or -)
3. Close the battery cover firmly.
 Inserting and Removing an SD Card（Optional）
The camera comes with 64 MB built-in memory which allows you to store pictures, movies,
recorded voice and music. You can expand the memory capacity by using an optional SD or
MMC memory card up to 4G. To insert a memory card, refer to the figure above and:
1. Insert the memory card into the right position.
2. To remove an installed SD card, press the card inwards to release
it.
3. When the card pops out, gently remove it from its slot.
Note
When a memory card is fitted, movies and pictures are
saved on card rather than on the built-in memory.
 Protecting Data on an SD Card
SD card is read-only by locking the SD card. No pictures, movies and voice can be recorded
when the SD card is locked. Make sure the lock is on writeable position before recording any
media.
Writeable position
Write-Protected
Position
Writeable position
Write-Protected
Position